Licensed & insured · SC License M 101503 · Serving Newberry County since 1985 (803) 276-9685 Mon–Fri 8:00 AM–5:00 PM

HVAC Frequently Asked Questions

The questions we are asked most often about heating, cooling, humidity and energy.

Have some questions about keeping your home comfortable? You are not alone. These are the questions we are asked most often about heating, cooling, humidity and energy. Nothing here is brand-specific — it is the same advice we would give across the counter.

What kind of system do I need to keep my home comfortable?

A complete indoor comfort system, not just a box. That means matched heating and cooling equipment, a correctly sized and sealed duct system, filtration that suits your household and, in the South Carolina humidity, deliberate moisture control. We size the system to the house with a load calculation rather than a rule of thumb, because an oversized air conditioner cools quickly, satisfies the thermostat and shuts off before it has removed the humidity.

What should I look for in a new furnace?

AFUE first. It tells you what share of the fuel becomes heat — 90 means 90% of the fuel warms your home while the rest leaves as exhaust. Then look for two-stage or modulating operation, a variable-speed blower, sealed combustion, hot-surface ignition, and a long heat-exchanger warranty. Lifetime limited warranties on heat exchangers are available on Bryant's Plus 90 models.

What should I look for in a new heat pump or air conditioner?

SEER for cooling and HSPF for heating. Higher numbers mean greater energy savings, the same way miles per gallon works on a car. Beyond the ratings, look for a certified matched indoor and outdoor combination, a quiet outdoor unit, a coil guard, and a compressor warranty. A 13 SEER unit uses about 23% less energy than a 10 SEER unit.

How do I compare the performance of heating and cooling products?

Compare the ratings on the matched system, not on the components. A condenser rated 16 SEER with a mismatched coil does not deliver 16 SEER. Ask the contractor for the indoor model, the outdoor model and the certified rating of that exact pair, and compare those numbers side by side.

Why do I need to "match" my condensing unit and outdoor coil?

Because the efficiency rating is a property of the pair. The coil controls how much heat the refrigerant can absorb and the compressor controls how hard it is pushed; the numbers published in the rating plate come from testing them together. Mixing brands or generations usually costs efficiency, capacity and compressor life — and often the warranty as well.

What should I ask my dealer or builder about before I purchase a system?

Ask for the load calculation, the certified matched model numbers and their combined rating, the duct design and whether the ducts will be sealed, the warranty terms and registration, and who will commission the system after installation. See our new home buyer's guide for the full checklist.

How do the components of an indoor comfort system work together?

The outdoor unit moves heat between the refrigerant and the outside air. The indoor coil moves it between the refrigerant and your air. The blower moves air across that coil and through the ducts. The thermostat decides when to run, and the filter and humidity accessories clean and condition the air on the way past. Change any one of them and the whole system's performance changes.

How do furnaces and boilers work?

A furnace heats air and distributes it through ductwork; a boiler heats water and distributes it through pipes to radiators, baseboards or a hydronic coil. In this part of South Carolina, forced-air furnaces and heat pumps are the norm because the same ductwork serves the air conditioning. Boilers survive mainly in older homes and some commercial buildings.

How do air cleaners and humidifiers work?

Media and electronic air cleaners trap particles as air passes through them. An electronic air cleaner first filters out large particles, then magnetises and attracts tiny ones like viruses and bacteria onto a collector plate. A humidifier adds water vapour to the heated air leaving the furnace, replacing the moisture that heating dries out and so protecting furnishings and reducing static.

How do heat and energy recovery ventilators work?

A ventilator captures heating or cooling energy from stale indoor air and transfers it to the incoming fresh air. You get ventilation — which tight modern houses need — without throwing away the energy you already paid for.

How do thermostats work?

A thermostat measures indoor air temperature and switches the equipment on and off, or modulates it, to hold the setting. A setback thermostat adds a built-in memory so you can program different temperatures at different times of day. A Thermidistat goes further: it monitors inside and outside temperature plus indoor humidity, and adjusts system operation to hold both the temperature and the humidity you set.

How do zoning systems work?

Zoning divides the house into areas with their own thermostats and motorised dampers in the duct work. The damper is a valve that opens or closes to control airflow, so each zone gets what it needs instead of one thermostat deciding for the whole house. Properly applied, zoning can improve comfort and cut energy use by as much as 30%.

What simple maintenance and troubleshooting can I do myself?

Change or clean the filter on schedule — a blocked filter is the most common cause of frozen coils and short compressor life. Keep the outdoor unit clear of leaves, grass clippings and shrubs. Check that supply registers are open and not blocked by furniture. Confirm the condensate drain is running and the drain pan is dry. Beyond that, leave refrigerant, gas and electrical work to a licensed technician.

When should I repair older equipment and when do I need to replace it?

Repair when the unit is under about ten years old, the repair is a modest share of replacement cost, and everything else is in good order. Replace when the equipment is 12 or more years old, uses R-22, needs a second major repair in three years, or has a cracked heat exchanger — that last one is a carbon monoxide hazard and is never optional.

How is energy use measured?

In BTUs for heating and cooling capacity, SEER for cooling efficiency, HSPF for heat pump heating efficiency and AFUE for furnace efficiency. One BTU is roughly the heat given off by a wooden kitchen match. One ton of cooling equals 12,000 BTUs per hour. Electricity is billed in kilowatt hours, which is what actually shows up on your utility statement.

What is the EPA's Energy Star programme?

Energy Star is the US Environmental Protection Agency programme that identifies products meeting efficiency levels above the federal minimum. Buying Energy Star equipment is a reasonable floor for a new system; in our climate, going above it usually pays back through the cooling season.

Are there new refrigerants available that are safer for the environment?

Yes. Puron® (R-410A) replaced ozone-depleting Freon 22® in new residential equipment and is approved by the EPA. If your existing system uses R-22, refrigerant will keep getting more expensive because it is no longer produced for new equipment.

What is the Green Seal programme?

Green Seal is an independent non-profit certification for products and services that meet environmental standards across their life cycle. It is the same idea as Energy Star but broader than energy use alone, and it is one of the certifications to look for on filters, sealants and cleaning products used in a home.

How often should I have my system serviced?

Once a year for each system — cooling in spring before the first heat wave and heating in autumn before the first cold snap. Annual service protects the manufacturer's warranty, keeps efficiency where the rating plate promises and finds weak capacitors, contactors and dirty coils while they are still inexpensive to fix.

Do you charge for estimates on replacement systems?

Replacement estimates and on-site comfort surveys are free within our service area. Diagnostic service calls on a non-working system are chargeable, and we tell you the cost before we book the visit so there are no surprises.

Still stuck?

Describe what the system is doing and we will tell you whether it is a service call or something you can check yourself. (803) 276-9685

Need a repair, a quote or a second opinion?

Call Wilson's Refrigeration and A/C Service and talk to the people who will actually do the work. Same-day service is available on most calls.