Licensed & insured · SC License M 101503 · Serving Newberry County since 1985 (803) 276-9685 Mon–Fri 8:00 AM–5:00 PM

Heating & Furnace Service

Furnace and heat pump repair, replacement and combustion safety inspection.

Furnace and heat pump repair

Carolina winters are short but not gentle. When a furnace quits, the house gets cold quickly, and a cracked heat exchanger is a carbon-monoxide hazard rather than an inconvenience. Every heating diagnostic we run includes a combustion and heat-exchanger inspection, not just a "does it light" check.

  • No heat at all. Ignition, flame sensor, gas valve, pressure switch or control board — all verified with instruments.
  • Short cycling. Often an oversized furnace, a blocked filter, an obstructed flue or a failing limit switch.
  • Yellow, lazy flame. A combustion problem. Gas pressure and air adjustment need checking immediately.
  • Heat pump stuck in defrost or running on auxiliary only. Usually a sensor, a reversing valve or a defrost board.
  • Rumbling or rattle on startup. Burner alignment, inducer motor bearings or a loose blower wheel.

No heat?

Call (803) 276-9685. If you smell gas, leave the house and call your gas utility first — then call us.

Request a service call

Heating safety

Keep the flue clear, never block a return-air grille with storage, and have the heat exchanger inspected annually once the furnace is over ten years old.

Furnace installation

A new furnace should last at least 15 years, and many last more than 20. The operating cost savings from a high-efficiency furnace pay back the extra first cost many times over compared with a government-mandated minimum efficiency unit. Many 1990 and earlier furnaces run at 65% or less; the federal minimum today is 78%, and Bryant equipment reaches 96.6% AFUE.

Single stage

Full output or nothing. Lowest first cost, widest temperature swing. Fine for mild climates and tight budgets.

Two stage

Runs on low fire most of the time, which means longer gentler cycles, quieter operation and better humidity control in cooling. Our usual recommendation here.

Variable speed blower

Holds airflow steady for better dehumidification in summer and up to 9% lower cooling costs. Pairs naturally with two-stage heating.

Heat pumps: the efficient choice when you have no gas

A heat pump is an air conditioner that can run backwards. Instead of burning fuel it moves heat from outside air into the house, which is why it can deliver more heat energy than the electricity it consumes.

Heat pumps are rated in SEER for cooling and HSPF for heating. Higher numbers mean greater savings, the same way miles per gallon works on a car. In our climate a heat pump covers almost the entire heating season, with electric backup for the handful of mornings below freezing.

The catch is the indoor unit. A heat pump needs a matched fan coil, and a variable-speed fan coil delivers noticeably warmer supply air — which is the difference between a heat pump that feels cold and one that feels like a furnace.

Fan coils and air handlers · Bryant system guide

Heating options compared for the Midlands
SystemStrengthWatch out for
Gas furnace + A/CStrong, fast heat on the coldest morningsRequires a gas supply; flue needed
Heat pump + fan coilMost efficient heating; also does the coolingNeeds matched indoor coil and good airflow
Dual fuelHeat pump for mild weather, furnace for cold snapsHigher first cost, control setup matters

Need a repair, a quote or a second opinion?

Call Wilson's Refrigeration and A/C Service and talk to the people who will actually do the work. Same-day service is available on most calls.